
Camera interfaces
STINGRAY Technical Manual V2.2.0
79
Control and video data signals
The inputs and outputs of the camera can be configured by software. The dif-
ferent modes are described below.
Inputs
The optocoupler inverts all input signals. Inversion of the signal is controlled
via the IO_INP_CTRL1..2 register (see Table 21: Advanced register: Input
control on page 80).
Triggers
All inputs configured as triggers are linked by AND. If several inputs are being
used as triggers, a high signal must be present on all inputs in order to gen-
erate a trigger signal. Each signal can be inverted. The camera must be set
to external triggering to trigger image capture by the trigger signal.
Note
L
For a general description of the inputs and warnings see the
Hardware Installation Guide, Chapter STINGRAY input
description.
Figure 44: Input block diagram
Input
Polarity
selectable
via software
Input state
Opto-
Coupler
Input signal
Comentarios a estos manuales